1.check

Modified the original car's appearance before the inspection, the distance light is normal, to normal conditions in the original car in order to further modification. (Note that much light hit the lights will not light when the observation of the past, some cars far lights bright lights near state. Installed far distance light will light while under light, which is normal, in some models is the distance light separate bright) modified according to user needs, first unplug the original car headlight control, power check whether the failure on the dashboard warning lights, high beam indicator does not light or flash. If the next step can be directly installed lights if the failure or other unusual circumstances should contact the manufacturer and professional recognition in order to further modification.

2.removal of the original car halogen bulb

Removal must be very careful not to damage the appearance of light and line cups, check and remove the halogen bulb type is the same model hernia. (Eg, different models can not be modified)

3.fixed xenon bulbs

Xenon lamp should be closely aligns the car lights Cup, if the installation xenon lamp cup holder and car astigmatism is not placed there will be problems when installing some attention, it is recommended to remove the installation more intuitive lamp cup. Note: As some of the original car seat deck lights are special, ordinary lamp holder can not be fixed after installation, you need to install special cup holder with the original lights, need to install special lamp models have BMW Series models , 04,05 Odyssey models, Volkswagen Jetta, Touran, the new Bora and so on.

4.holes

Waterproof cast open the hole diameter of 2225mm, and xenon lights leads through the hole from the hole and block the hole with a rubber ring, rubber ring if plugged larger clearance hole must be rubber adhesive ring sealed. Note: If you remove the original halogen bulbs do not need to dismantle the car models you do not need waterproof cover in a waterproof cover openings.

5.fixed ballast

As far as possible away from the car to install ballast engine (such as engines, tanks, etc.), so as not to affect the life of the ballast, the best installation location is in the bumper, headlight assembly beneath or beside it. Note: When possible, use fixed ballast mounting bracket screws or fastening.

6.Connection

Connection with the original car xenon bulb socket input power cord, connecting with the xenon bulb ballast input power cord, connecting the high-voltage ballast and the lamp plug. Note: The dual-lamp products, light products, telescopic, swinging lamps (H4, H13, 9004,9007) need to take power in the battery, when connecting the line to ensure that the original car is not power, grounding in the body connected to the negative and be sure To screw with a blade or rasp to a new twist on its surface, so that the body good contact with the wire ear.

7.check

Check the xenon lamp is fixed in place: waterproof apron is sealed; ballast is securely; connection is correct, complete original car parts firm screws, clean the installation site, so that tools or other items not near the engine. Open the engine power test lamp is lit, with or without bad situation. In determining the non-poor case, harness, lead with a tie fixed to the body, especially the fundamental line of high voltage output of ballast must be fixed in the body so as to avoid cars in your work makes high-frequency vibrations caused by breaking line leaving the ballast does not work.

8.power tests

Open the engine, adjust the lamp-shaped lighting, check the light pattern is correct, do a good job placement records to prepare for the next installation or maintenance inspection.

Keywords: xenon lamp

prev： Used car buying tips car vehicle in good and bad lighting can be revealed(2011-04-19)

next：BMW 6 Series Coupe official map lights eye headlight designed by shark(2011-04-16)