Disassembly to install HID xenon lamp may cause dangerous accidents.

* When the power switch lights, do not touch the lamp, so as to avoid the heat released by a large number of burns.

* Car accident and hit the xenon headlight system, immediately turn off the lamp power, because of the damaged high-voltage ignition coil line group will leak, be dangerous.

* Have to start the car after, and then open the car xenon headlamps.

* Must turn off your vehicle engine prior to HID Xenon lights off.

* A few seconds, such as fast light / off Xenon car lights, light bulbs can cause damage or shortened life span.

* Summer, night time hiking and highway driving, the engine room prone to overheating, if found headlights suddenly went out, do not panic, this phenomenon is that xenon headlights regulator installation location is not appropriate. Caused overheat, driving the car immediately to the side of the road and turn off the lights power, the engine room to be cool, you can automatically return to normal, and go to car repair workshop to adjust the installation location.

* Auto headlight assembly phenomenon of rupture or leakage, the absolute prohibition of rain turn on the lights to avoid danger.

* Auto headlamps on, xenon headlights light up, if not immediately, do not frequent lighting / lights-out, patient wait for the regulator (central processing unit CPU) the system will automatically lighting, continued to light so far . If the minutes is not lit, please check the repair station, or cause regulator burned.

* Car headlights or just turn off the lights when lit, do not touch the hands or skin because the lamp is very hot, may cause burns, car wash or touch * near the site of car headlights, the first fully cool before operation.

* Do not look directly at the light lit, as the eyes can cause pain or visually impaired, do not * close look when lit.

* Distance light switch must be 2 to 3 seconds to do a switch, or likely to cause damage.

• Do not light up when the engine in order to protect and extend the life of xenon headlights.

• In xenon headlights not turned on, do not use the switch to do to overtake overtaking maneuver, or may cause damage to xenon headlamps

* When using the distance light, ultra-light action or do not switch a total of more than ten times per minute switch, otherwise it will create scalable conversion caused by burning of the solenoid valve can not switch high and low lights.

prev：How to check auto lamp lights inspection method(2011-04-29)

next：Change the lights to learn before the knowledge of some of the light(2011-04-26)